You can install toilet drain pipes yourself, but you have to make sure the drain and vent system works properly. Installation mistakes may result in health hazards due to sewer gas leaks. Once you choose the toilet position, you have to decide how to run the drain pipe via the most direct route. Keeping to the minimum slope for the pipe and making sure it is vented adequately are important. Sometimes moving the location of the toilet slightly can make your job much easier.
First of all is checking with your local authorities regarding building codes and permit requirements. Make sure you satisfy the code regarding the size of the drain pipe and the size of the vent. Plan your work to include any necessary inspections.
Look for the main plumbing stack in your basement or crawlspace and take note of where it goes up through the house and where it exits on the roof. Find where the other other large waste drain pipes run. Look for pipes you can use for venting. Determine where you can access the drain pipes, main stack and vent pipes to connect the toilet.
Make a detailed plan of where you will run your toilet drain pipes. Plan to open walls and remove flooring if necessary. Your toilet has an integrated trap, so you can plan for a direct drain connection with as few bends as possible.
Make sure you have enough room to install the sanitary tee to connect to the main stack or the combo fitting to connect to a horizontal drain. Check your building code to find limits on how long your toilet drain pipe may be before venting and before connecting to the stack.
Installing the Pipes
Cut the pipes and assemble them without gluing to make sure they are the right lengths and that they fit in the allocated space. Check that you have fittings to match your pipes to the existing drain and vent pipes.
Make sure your stack or existing drain is firmly supported above and below the planned location of your connection, otherwise, it will cause toilet leak and you will have to fix a running toilet. Add support braces if necessary. Cut the existing pipe and remove a length equal to the length of the sanitary tee or combo fitting.
If there is enough play in the existing drain pipes to insert the new fitting, apply pipe cleaner and then pipe glue to the flange and the fitting, insert the fitting and twist it fully into the flange. If you can’t move the existing stack or drain pipes, get a no-hub flexible coupling and cut out an additional length of existing pipe equal to the length of the coupling. Glue the additional length of pipe into the upstream flange of the fitting. Slide the coupling onto the upstream existing pipe. Glue the fitting into place on the downstream pipe. Slide the coupling over the joint and tighten.